Printing with CPX

Printing with CPX Kyronmax (Copoly)

For Help with Loading the CPX, Please see our filament loading guide

When swapping to the Copoly Printing bed, you may need to raise the Z-Offset to compensate for the thicker bed. Be sure to note your original Z-Offset before you change it. Here is our Setting the Z-Offset Guide!

Prep Copoly Plate with BuildTak Bond:

Lift the old flex plate off using the blue or green handles. See the orange circles from the picture below as the bed is magnetic and lifts up.

Apply BuildTak Bond on cold Copoly plate.

Click Preheat on the main screen and let the bed reach it's 60°C Temperature. Afterwards, let the bed sit for 10 minutes as it dries.

After the Bond dries, you are ready to start printing. Feel free to start your first Copoly print and let us know how it goes!

The layer of BulidTak Bond will last for 5 prints before having to be cleaned and reapplied.

Before

After

Removing Copoly from the Print Bed

After a print has been completed, select Preheat on the Main Screen to heat the bed to 60°C.

Wait for the Bed to reach it's 60°C Temperature before continuing

Using the scraper, Carefully peel the print from the bed, being sure not to use too much pressure. We don't want to remove the bed's coating or anymore glue than necessary

Updated on: 30/01/2026

Was this article helpful?

Thank you!