Returning a Kiosk

Supplies:

Large roll of wrapping foam
Plastic wrap
Two pieces of foam for the printer bed
One piece of foam for the printer toolhead
Masking tape

Note: Take pictures of the kiosk packaging inside and out, and send them to us. This will ensure you are not liable for any damages that may occur during shipping.

Procedure:

Begin by unplugging all of the cords and shutting off the printer.
Next wrap all loose pieces in foam and place in the bottom drawer

Filament holder handle
Filament rolls
Extra beds, or toolheads
Tools, tablets, and additional parts

On the inside, there are a few places you need to secure:

Tape down the LED lights in the back.
Pack foam around the toolhead to prevent it from moving.
Pack foam around the bed to prevent it from moving backwards and forwards.
Remove the filament roll and the filament handle from inside the kiosk. You can put those in the drawer.

Wrap the kiosk in in a layer of cardboard and then a layer of foam to protect from dents and scratches. Then, wrap it again with plastic wrap to keep the foam secured in place.

Let us know it’s ready for pick up, and send us photos of the assembly.

Thank you!

Updated on: 14/10/2025

Was this article helpful?

Yes
No

Thank you!